Table of Contents
Advertisement
Chapter 5
CLI Commands
clralms
To clear alarms on a VISM card, use the clralms command in the VoIP switching/trunking, switched
AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
This command can clear alarms caused only by the collection of statistical data. Alarms caused by
network failure cannot be cleared. For example, an alarm caused by a collection of bipolar errors can be
cleared, but an alarm caused by a line failure cannot. Alarms occurring after this command executes are
not affected.
Examples
The following example shows that the alarms are cleared on the current VISM card:
clralms
Related Commands
Command
clralm
dspalm
dspalms
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
clralms
Description
Clears alarms on a specific line of a VISM card.
Displays the alarms associated with a specified line.
Displays all alarms for the selected line type on a VISM card.
Cisco VISM Installation and Configuration Guide
clralms
5-55
Advertisement
Table of Contents
