Table of Contents
Advertisement
Chapter 5
CLI Commands
addendptloop
To place an endpoint in a loopback condition in the TDM direction, use the addendptloop command in
the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
endpt-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example adds an endpoint loopback to endpoint 120:
addendptloop 120
Related Commands
Command
delendptloop
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
addendptloop endpt-num
Endpoint number. It can be a value from one of the following ranges:
For template number 1:
•
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
For template number 3:
•
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 4:
–
For VISM-PR, from 1 to 144
Description
Takes an endpoint out of a loopback condition.
Cisco VISM Installation and Configuration Guide
addendptloop
5-21
Advertisement
Table of Contents
