Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 557

Voice interworking service module release 3.0
Table of Contents

Advertisement

Chapter 5
CLI Commands
dsprtpcons
To display the configuration data of all static Real-Time Transport Protocol (RTP) VoIP trunking
connections, use the dsprtpcons command in the VoIP switching/trunking and VoIP and switched ATM
AAL1 SVC operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration data for all static RTP connections are displayed:
dsprtpcons
Connection Endpoint Local Rtp Remote RTP
Index
---------- -------- --------- ----------
Related Commands
Command
addlapdtrunk
addrtpcon
addrudptrunk
clrrtpcnt
cnflapdtrunkpvc
cnflntrunkcond
cnfrtpcon
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI backhaul RUDP
dellapdtrunk
delrtpcon
delrudptrunk
dsplapd
dsplapdtrunkpvc
dsplapdtrunks
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsprtpcons
Number
Port
1
1
49700
2
2
49702
Description
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
Modifies an existing static RTP VoIP trunking connection.
trunk for a specified session.
Deletes an LAPD configured line.
Deletes a static RTP VoIP trunking connection.
Deletes an ISDN PRI backhaul RUDP session that is associated with an LAPD.
Displays data about an LAPD.
Displays the assigned PVC trunk type that carries LAPD trunk messages for
the current VISM card.
Displays the configuration data of all LAPD trunks.
Remote IP
Port
Address
---------------
49700
209.165.200.224
49702
209.165.200.225
Cisco VISM Installation and Configuration Guide
dsprtpcons
Codec Packetization
Type
Period
----- -------------
----------
G711u
ten
G.711u
ten
Alarm
State
Active
Active
5-413

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vism 3.0

Table of Contents