Table of Contents
Advertisement
Chapter 5
CLI Commands
addendpt
To add an endpoint on a VISM card line, use the addendpt command in the VoIP switching/trunking,
switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
endpt-num
ds1-num
ds0-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
The endpoint on VISM is a logical port that consists of one DS0. The argument values entered in this
command create an endpoint ID (endpt-num) which is required by the call agent for sending the xGCP
Create Connection command (CRCX) to a VISM card. You can only configure bearer DS0s as endpoints
to a previously added line.
Note
The endpoint number is not equal to the DS0 number of the associated time slot. For example,
endpoint 1 could be associated with DS011.
If your application requires the VoIP switching/trunking operating mode, you must add the IP address
for VISM with the cnfvismip command before endpoints can be added.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
addendpt endpt-num ds1-num ds0-num
Endpoint number. It can be a value from one of the following ranges:
For template number 1:
•
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
For template number 3:
•
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 4:
–
For VISM-PR, from 1 to 144
Physical line number in the range from 1 to 8.
DS0 configured for the endpt-num value. It can be a value from one of the following
ranges:
For T1 lines, from 1 to 24
•
For non-CAS E1 lines, from 1 to 31
•
For CAS E1 lines, from 1 to 15 and 17 to 31
•
Cisco VISM Installation and Configuration Guide
addendpt
5-19
Advertisement
Table of Contents
