Chapter 4
Configuring VISM Features
•
•
You have completed assigning and configuring the codec template. Proceed to the
section on page
Configuring ECAN
Complete the following steps to enable and configure echo cancellation (ECAN) on a line-by-line basis:
Type the cnfecanenable command, line-num and ecan-enable argument values, and press Enter to
Step 1
enable (or disable) ECAN for a line. Specify the arguments with the following values:
•
•
Step 2
Type the cnfecanrec command, line-num and res-echo-control argument values, and press Enter to set
the residual echo control. Specify the arguments with the following values:
•
•
Type the cnfecantail command, line-num and max-ecan-tail argument values, and press Enter to specify
Step 3
the ECAN algorithm's maximum tail length. Specify the arguments with the following values:
•
•
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
5 = Local MIB, LCO list, remote SDP data list
6 = Local MIB, remote SDP data list, LCO list
4-29.
line-num: In the range from 1 to 8.
ecan-enable:
1 = Disable
–
2 = Enable
–
line-num: Type the value used in
res-echo-control:
–
1 = Cancel only
–
2 = Suppress residual
–
4 = Comfort noise
line-num: Type the value used in
max-ecan-tail (defined in milliseconds):
24
–
–
32
–
48
–
64
–
80
–
96
112
–
128
–
Step
1.
Step
1.
Cisco VISM Installation and Configuration Guide
Configuring VISM Features
"Configuring ECAN"
4-29