Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfrtcprepint
To configure the Real Time Control Protocol (RTCP) report interval for a VISM card, use the
cnfrtcprepint command in the VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
operating modes.
Syntax Description
report-interval
report-mult
Command Modes
VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the RTCP report packet interval is configured at 1000 ms:
cnfrtcprepint 1000
Related Commands
Command
dspvismparam
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfrtcprepint report-interval |report-mult|
Interval (defined in milliseconds) between RTCP report packets sent to peer VoIP
endpoints. It can be in the range from 500 to 1500, in increments of 10.
(Optional) Interval multiplier for the report-interval argument value. Use this
argument if you need to configure the report-interval argument value higher than
the maximum (1500 ms). It can be in the range from 1 to 10. (Default = 3)
Note
If report-interval = 1500 and report-mult = 3, then 1000 * 3 = 4500. So,
the interval time between RTCP report packets sent to peer VoIP
endpoints is configured as 4500 ms.
Description
Displays current VISM card configuration.
Cisco VISM Installation and Configuration Guide
cnfrtcprepint
5-197
Advertisement
Table of Contents
