Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 469

Chapter 5 CLI Commands
dspcids
To display all AAL2 channel identifiers (CIDs) for an LCN on the current VISM card, use the dspcids
command in the switched AAL2 PVC and AAL2 trunking operating modes.
Syntax Description
lcn
Command Modes Switched AAL2 PVC and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples The following example shows that the AAL2 CIDs are displayed for LCN 132:
dspcids 132
lcn CID Endpt
Num Num
--- --- ----- ------ ----- --- ----- ------ ---- --------- ---- ---- ----
132
Related Commands Command
addcid
delcid
dspcid
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspcids lcn
Logical channel number of the LCN for which you want to display AAL2 CIDs. It can
be in the range from 131 to 510.
Cid Type3
Num Status Redun VAD Timer Type
9 1 active ena
Description
Adds an AAL2 CID on a VISM card.
Deletes the association between an endpoint and an LCN/CID pair.
Displays the configuration data of an AAL2 CID on the current VISM card.
VAD Prof Prof
Num Type
ena 250 ITU 1
Cisco VISM Installation and Configuration Guide
Codec Cas DTMF
Tran Tran Ecan
G.711u ena ena ena
dspcids
5-325