Table of Contents
Advertisement
cnfgwoos
cnfgwoos
To configure an in-service VISM card to the out-of-service state, use the cnfgwoos command in the VoIP
switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
oos-method
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Associated call agents are notified of VISM card state changes with an RSIP notification.
Examples
The following example shows that the current VISM card is placed in the out-of-service state forcefully:
cnfgwoos 2
The VISM card prompt terminates with an s to indicate the out-of-service (standby) state:
NODENAME.1.9.VISM8.s
Related Commands
Command
cnfgwis
dspgwstate
Cisco VISM Installation and Configuration Guide
5-152
cnfgwoos oos-method
VISM card's method of reaching the out-of-service state. It can be one of the
following values:
•
2 = Forceful. Existing connections are deleted and the VISM card transitions to the
"commandedOutOfService" state. New connection requests are rejected.
3 = Graceful. Existing connections are not released and allowed to terminate
•
naturally. Immediately after this command is executed, the VISM card transitions
to the "pendingOutOfService state". New connection requests are rejected. The
VISM card transitions to the 'commandedOutOfService' state only when all
ongoing connections are deleted by the call agent.
Description
Configures an out-of-service VISM card to the in-service state.
Displays the current user-configured service states of the gateway.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
