dsplapdstat
dsplapdstat
To display configuration data about Link Access Protocol for ISDN D channel (LAPD) statistics
(counters) for a specific line and DS0, use the dsplapdstat command in the VoIP switching/trunking
operating mode.
Syntax Description
line-num
ds0-num
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the LAPD statistic configuration data for line number 1, DS0 number
1 are displayed:
dsplapdstat 1 1
vismLapdStatsIndex:
vismLapdRxInfoFrames:
vismLapdTxInfoFrames:
vismLapdRxReadyFrames:
vismLapdTxReadyFrames:
vismLapdRxNotReadyFrames:
vismLapdTxNotReadyFrames:
vismLapdRxSABMFrames:
vismLapdTxSABMFrames:
vismLapdRxDisconFrames:
vismLapdTxDisconFrames:
vismLapdRxUAFrames:
vismLapdTxUAFrames:
vismLapdRxDiscModeFrames:
vismLapdTxDiscModeFrames:
vismLapdRxFrmRejectFrames:
vismLapdTxFrmRejectFrames:
vismLapdRxExchIdFrames:
vismLapdTxExchIdFrames:
vismLapdRxUnumInfoFrames:
vismLapdTxUnumInfoFrames:
vismLapdRxRejectFrames:
vismLapdTxRejectFrames:
vismLapdRxInvalidFrames:
Cisco VISM Installation and Configuration Guide
5-354
dsplapdstat line-num ds0-num
Line number of the channel for which you want to display the LAPD statistics. It can
be in the range from 1 to 8.
DS0 number of the channel for which you want to display the LAPD statistics. It can
be a value from one of the following ranges:
•
1 to 24 for T1 lines
1 to 31 for E1 lines
•
1
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands