Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 607

Chapter 5 CLI Commands
dspxgcpcnf
To display previously configured Simple Gateway Control Protocol (SGCP)/Media Gateway Control
Protocol (MGCP) timeout and retransmission count values, use the dspxgcpcnf command in the VoIP
switching/trunking operating mode.
Syntax Description
This command has no arguments or keywords.
Command Modes VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the SGCP/MGCP timeout and retransmission count values are
displayed:
dspxgcpcnf
MWD timeout :
Request timeout :
Retry count:
Related Commands Command
cnfxgcpmwd
cnfxgcpretry
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspxgcpcnf
10000
500
3
Description
Configures the maximum waiting delay value used for sending an RSIP message to
the call agent.
Configures VISM minimum and maximum request timeouts and retransmission
attempts for communication with the associated call agent.
Cisco VISM Installation and Configuration Guide
dspxgcpcnf
5-463