Table of Contents
Advertisement
Chapter 5
CLI Commands
dspdns
To display the configuration data of all domain names of a call agent, use the dspdns command in the
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration data of the mgc1 domain name are displayed:
dspdns
DomainNumber
------------
Related Commands
Command
adddn
adddnip
cnfdn
cnfdnssrvr
deldn
delnip
dspdnallips
dspdnips
dspdnssrvr
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspdns
DomainName
----------
-----------
1
mgc1
nn.nn.nn.nn
Description
Adds a domain name (call agent name) and optionally configures the resolution type
of the domain name.
Adds the IP addresses for a domain name that you added by using the adddn
command.
Configures the resolution type of a specified domain name.
Designates a domain name as a DNS.
Deletes a domain name.
Deletes a statistically provisioned IP address of a domain name.
Displays all statistically provisioned IP addresses and externally resolved IP
addresses for all domain names configured on the current VISM card.
Displays all statistically provisioned and externally resolved IP addresses configured
for a specified domain name.
Displays the domain name of the configured DNS of the current VISM card.
IP
State
Preference
-----
----------
Active
1
Cisco VISM Installation and Configuration Guide
Resolution Type
---------------
internal only
dspdns
5-339
Advertisement
Table of Contents
