Chapter 4
Configuring VISM Features
Type the cnfdeftos command, control-prec, control-tos, |bearer-prec|, and |bearer-tos| argument values,
Step 2
and press Enter to configure the type of service for both control and bearer IP packets.
Note
Specify the arguments with the following values:
control-prec: In the range from 0 to 7 (default = 3)
•
•
control-tos (type of service for control packets):
–
–
–
–
–
bearer-prec: In the range from 0 to 7 (default = 5)
•
bearer-tos (type of service for bearer packets):
•
–
–
–
–
–
Note
Type the cnfvoiptransparams command, dtmf-trans, cas-trans, and |event-neg-enable|, |event-neg-pol|,
Step 3
and |sid-type| argument values, and press Enter to configure the VoIP transportation characteristics
across the network. Specify the arguments with the following values:
•
dtmf-trans (DTMF tones relayed to the other endpoint):
–
–
cas-trans (CAS bits relayed to the other endpoint):
•
–
–
•
event-neg-enable (Optional):
–
–
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
If you do not execute the cnfdeftos command, card level default values are used.
0 (default)
1
2
4
8
0 (default)
1
2
4
8
The bearer-prec and bearer-tos arguments are used during call setup in cases where
values are not supplied by a call agent.
1 = On
2 = Off
1 = On
2 = Off
1 = On
2 = Off
Cisco VISM Installation and Configuration Guide
Configuring VISM Features
4-35