Table of Contents
Advertisement
delmgcgrpprotocol
delmgcgrpprotocol
To delete a Media Gateway Control Protocol (MGCP) from a specified call agent redundancy group, use
the delmgcgrpprotocol command in the VoIP switching/trunking and switched AAL2 PVC operating
modes.
Syntax Description
mgc-group
protocol-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that protocol number 2 is deleted from call agent redundancy group
number 3:
delmgcgrpprotocol 3 2
Related Commands
Command
addmgcgrpentry
addmgcgrpprotocol
cnfdisctimers
cnfmgcgrpentry
cnfmgcgrpparam
cnfmgcgrpprotocol
cnfsrcppeer
Cisco VISM Installation and Configuration Guide
5-264
delmgcgrpprotocol mgc-group protocol-num
Call agent redundancy group number. It can be in the range from 1 to 8.
Protocol number. It can be one of the following values:
1 = MGCP 0.1
•
2 = SGCP 1.1+
•
•
3 = SRCP 1.0.2
•
4 = SGCP 1.5
•
5 = MGCP 1.0
In the range from 6 to 8, as displayed by the dspmgcgrpprotocols command.
Description
Configures call agents as part of an MGC redundancy group and assigns a
priority value for a call agent.
Associates a call agent redundancy group to a gateway control protocol.
Specifies the wait delay times for the disconnected procedure, restart in
progress command—initial, minimum, and maximum timer values.
Modifies the call agent priority level of a call agent within a call agent
redundancy group.
Modifies a call agent redundancy group state change notification policy
and priority level.
Configures call agent group protocol data.
Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
