Table of Contents
Advertisement
tstdelay
tstdelay
To test the delay on a specified connection, use the tstdelay command in the VoIP switching/trunking,
switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
lcn
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the delay for the connection identified by logical channel number 136
is tested:
tstdelay 136
Related Commands
Command
tstcon
Cisco VISM Installation and Configuration Guide
5-488
tstdelay lcn
Logical channel number of the connection for which to test the delay. It can be a value
in the range from 131 to 510.
Description
Tests a specified connection.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
