Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfcasvar
To configure a previously added channel associated signaling (CAS) variant timing parameters, use the
cnfcasvar command in the VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
var-name
country-code
partial-time
critical-time
interdigit-timeout
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures when using this command.
Examples
The following example shows that the var1 CAS variant for the nz country code is configured with a
partial timeout of 10 seconds, a critical timing of 10 seconds, and an MF interdigit timeout of 2 seconds:
cnfcasvar var1 nz 10 10 2
Related Commands
Command
addcasvar
delcasvar
dspcasvar
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfcasvar var-name country-code partial-time critical-time interdigit-timeout
Name of a previously added CAS variant; a text string of 1 to 64 alphanumeric
characters.
The country code of the variant. The value must be a two-character text string.
The partial dial time (defined in seconds) in the range from 10 to 10000—in
increments of 10.
The critical timing (defined in seconds) in the range from 0 to 10000—in
increments of 10.
The interdigit timeout value for MF digits (defined in seconds) in the range from
1 to 10.
Description
Adds a CAS variant to a VISM card.
Deletes a CAS variant from a VISM card.
Displays information about CAS variants for a given variant name.
Cisco VISM Installation and Configuration Guide
cnfcasvar
5-111
Advertisement
Table of Contents
