Table of Contents
Advertisement
addses
addses
To add a PRI backhaul session between a VISM card and a call agent, use the addses command in the
VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
session-num
group-num
priority
local-port-num
remote-port-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
You must add a session group for the session before you use this command.
Examples
The following example shows that PRI backhaul session number 4 is added to session group 2 between
the VISM card and the callagent1 call agent:
addses 4 2 2 1124 1124
Related Commands
Command
delses
dspses
dspsess
Cisco VISM Installation and Configuration Guide
5-42
addses session-num group-num priority local-port-num remote-port-num
Identifying session number in the range from 1 to 64.
Note
Identifying session group number to which the session is added in the range
from 1 to 16.
Note
Priority level; determines which session becomes active if a session fails within
the same group. It can be in the range from 1 (highest) to 4 (lowest).
Local port number. The VISM port number used for the session. It can be in the
range from 1124 to 65535.
Remote port number. The call agent port number used for the session. It can be
in the range from 1124 to 65535.
Description
Deletes a PRI backhaul session.
Displays information about a PRI backhaul session.
Displays information about all PRI backhaul sessions.
Up to 64 sessions can be created in a session group.
Currently, only group 1 is supported.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
