Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 573

Chapter 5 CLI Commands
dspsrcpcnt
To display the Simple Resource Control Protocol (SRCP) message counters (statistics) for a specified
call agent, use the dspsrcpcnt command in the VoIP switching/trunking operating mode.
Syntax Description
ca-ip-address
Command Modes VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples The following example shows that the SRCP message counters (statistics) of IP address 209.165.200.224
are displayed:
dspsrcpcnt 209.165.200.224
Ip
---------
2.2.2.2
Related Commands Command
dspsrcpcnts
dspsrcppeer
dspsrcppeers
dspsrcpport
dspsrcpretry
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspsrcpcnt ca-ip-address
IP address of the call agent for which you want to display SRCP statistics. It can
be in dotted decimal format (nnn.nnn.nnn.nnn).
Name Discarded
-------- ---------
mgc1 0
Description
Displays SRCP message counters (statistics) for all known call agents.
Displays the peer configuration data for a specified SRCP peer (call agent).
Displays the peer configuration data for all known SRCP peers (call agents).
Displays the local UDP port number used by the SRCP on VISM.
Displays the card level SRCP retransmission parameters—maximum number
of retransmission attempts, minimum timeout, and maximum timeout.
Augw/Fail Auln/Fail Ntfy/Fail
--------- --------- ---------
0/0 0/0
Cisco VISM Installation and Configuration Guide
Rqnt/Fail
---------
0/0 0/0
dspsrcpcnt
5-429