Table of Contents
Advertisement
Chapter 5
CLI Commands
addrscprtn
To add a resource partition for a virtual port, use the addrscprtn command in the VoIP
switching/trunking, switched AAL2 PVC, AAL2 trunking, AAL1 SVC, AAL2 SVC, and AAL1/VoIP
(for TDM grooming) operating modes.
Syntax Description
control-id
Command Modes
VoIP switching/trunking, switched AAL2 PVC, AAL2 trunking, AAL1 SVC, AAL2 SVC, and
AAL1/VoIP (for TDM grooming)
Usage Guidelines
You must configure a virtual port with the addport command before you use this command.
If the VISM card is reset after executing an addport command but before using this command, an
Note
error message is displayed. The error has no effect on the system and can be ignored.
If you are using a PXM1 card, this command adds an entry with resource partition number 1. If you are
using a PXM1E card, this command adds the entries with resource partition numbers 225 and 2,
respectively.
Examples
The following example shows that a resource partition is added to controller number 2:
addrscprtn 1
Related Commands
Command
delrscprtn
dsprscprtn
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
addrscprtn control-id
The controller identification number to which the resource partition is added. It can
be one of the following:
•
1—for a PXM1 card
2—for a PXM1E or PXM45 card
•
In the range from 3 to 255
•
Description
Deletes a resource partition.
Displays information about a resource partition.
Cisco VISM Installation and Configuration Guide
addrscprtn
5-35
Advertisement
Table of Contents
