Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfco4timer
To configure the bearer continuity test CO4 timer value, use the cnfco4timer command in the VoIP
switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
co4-timeout
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
A timer is started when a CO3 or xRBK message is sent. If a CO4 message is not received before the
timeout expires, a VISM initiated DLCX message is sent to the call agent.
Examples
The following example shows that the bearer continuity test CO4 timer expires at 10000 ms:
cnfco4timer 10000
Related Commands
Command
dspco4timer
dspvismparam
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfco4timer co4-timeout
It can be a value (defined in milliseconds) in the range from 50 to 10000. (Default =
1000)
Description
Displays the bearer continuity test CO4 timer value.
Displays the current VISM card configuration.
Cisco VISM Installation and Configuration Guide
cnfco4timer
5-117
Advertisement
Table of Contents
