Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfxgcpinteropsdpost
To enable or disable the Session Descriptor Protocol (SDP) OST interoperability in the call control protocol,
use the cnfxgcpinteropsdpost command in the VoIP switching/trunking operating mode.
Syntax Description
sdp-ost-enable
Command Modes
VoIP switching/trunking
Usage Guidelines
When a CRCX or MDCX command is received from the call agent, VISM can respond by building SDP
OST (O =, S =, and T = lines).
If a peer gateway does not support SDP OST, this command can be used to prevent VISM from building
SDP OST lines.
Examples
The following example shows that SDP OST interoperability is disabled:
cnfxgcpinteropsdpost 2
Related Commands
Command
dspxgcpinterops
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfxgcpinteropsdpost sdp-ost-enable
Enables or disables SDP OST interoperability. It can be one of the following
values:
•
1 = On (default)
2 = Off
•
Description
Displays the SDP OST interoperability feature configuration.
Cisco VISM Installation and Configuration Guide
cnfxgcpinteropsdpost
5-235
Advertisement
Table of Contents
