Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 325

Voice interworking service module release 3.0
Table of Contents

Advertisement

Chapter 5
CLI Commands
cnfmgcgrpparam
To modify a call agent redundancy group state change notification policy and priority level, use the
cnfmgcgrpparam command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
operating modes.
Syntax Description
mgc-group
state-change-notify
mgc-pref
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that call agent redundancy group number 1 is associated with the call
agent and is assigned a priority level of 5:
cnfmgcgrpparam 1 2 5
Related Commands
Command
addmgcgrpprotocol
cnfmgcgrpentry
cnfsrcppeer
cnfsrcppeergrpparam
delmgcgrpentry
delmgcgrpprotocol
dspmgcgrpparams
dspmgcgrpprotocols
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfmgcgrpparam mgc-group state-change-notify |mgc-pref|
Call agent redundancy group number. It can be in the range from 1 to 8.
State change notification. Determines if messages, such as RSIPs, are sent
to notify the call agent of a VISM card state change. It can be one of the
following values:
(Optional) Call agent priority value. It can be one of the following:
Description
Associates a call agent redundancy group to a gateway control protocol.
Modifies the call agent priority level of a call agent within a call agent
redundancy group.
Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.
Modifies the SRCP heartbeat interval and maximum UDP size for a
specified call agent redundancy group.
Deletes a call agent from a call agent redundancy group.
Deletes an MGCP from a specified call agent redundancy group.
Displays all configured call agent redundancy group parameters.
Displays all configured call agent redundancy group protocols.
1 = Enable (Default)
2 = Disable
0 = No gateway initiated requests or commands are sent.
In the range from 1 (highest) to 8 (lowest). (Default = 1)
Cisco VISM Installation and Configuration Guide
cnfmgcgrpparam
5-181

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vism 3.0

Table of Contents