Table of Contents
Advertisement
dspt38nsetimeout
dspt38nsetimeout
To display a specified configured line with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode, use the dspt38nsetimeout command in the
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the length of time in which to wait for a remote acknowledgment of
the offer to switch to fax transfer mode configured for line 5 is displayed:
dspt38nsetimeout 5
line_number: 5
FX_Nse_Timer: 1000 ms
Related Commands
Command
cnfcodectmpl
cnft38fxlco
cnft38nsetimeout
cnft38params
dspcodectmpls
dspt38fxlco
dspt38fxlcos
dspt38nsetimeouts
dspt38params
Cisco VISM Installation and Configuration Guide
5-438
dspt38nsetimeout line-num
Line number of the channel, in the range from 1 to 8.
Description
Assigns a codec template to an entire VISM card.
Configures the fax handling instructions for a specified line.
Configures a specified line with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
Configures the T.38 fax transfer parameters for a specified line.
Displays all entries in the codec template table.
Displays the fax handling instructions configured for a specified line.
Displays the fax handling instructions for all lines on the current VISM card.
Displays all configured lines with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
Displays the T.38 fax transfer parameters for a specified line.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
