Table of Contents
Advertisement
dsplnstate
dsplnstate
To display the service state of specified T1 or E1 line with respect to the xGCP protocol, use the
dsplnstate command in the VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Service states are expressed as administrative or operational. For each service state there is an actual
state and an effective state. The actual states are described in the following list:
•
•
The effective administrative state is the combination state of the gateway and the line.
The effective operational state is the combination alarm state of the gateway and the line.
Examples
The following example shows that the service states of line 1 are displayed:
dsplnstate 1
Line number : 1,
Line number : 1,
Related Commands
Command
dspgwstate
Cisco VISM Installation and Configuration Guide
5-374
dsplnstate line-num
Line number for which you want to display the service state. It can be in the range
from 1 to 8.
Actual administrative states:
–
In service
–
Pending out of service
Command out of service
–
Inactive
–
Invalid state
–
Actual operational states:
–
Alarm
–
OK
Actual admin. state : Inactive
Actual oper.
Effective admin. state : Inactive
Effective oper.
Description
Displays the current user-configured service states of the gateway.
state : OK
state : OK
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands
Advertisement
Table of Contents
