Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 507

Chapter 5 CLI Commands
dsplncids
To display the channel identification (CID), endpoint, and AAL2 configuration data for a VISM card
line, use the dsplncids command in the switched AAL2 PVC and AAL2 trunking operating modes.
Syntax Description
line-num
Command Modes Switched AAL2 PVC and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples The following example shows that the CID, endpoint, and AAL2 configuration data for line 2 are
displayed:
dsplncids 2
lcn CID Endpt
Num Num
--- --- ----- ------ ----- --- ----- ------ ---- --------- ---- ---- ----
33
Note If you configure the codec type as clear for the line number identified by the line-num argument, the
Type3 Redun, Cas Tran, DTMF Tran, and Ecan values are not applicable.
Related Commands Command
addcid
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsplncids line-num
Line number for which you want to display the CID, endpoint, and AAL2
configuration data. It can be in the range from 1 to 8.
Cid Type3
Num Status Redun VAD Timer
10 2 active ena ena
Description
Adds an AAL2 CID on a VISM card.
VAD Prof Prof Codec
Type Num Type
250 ITU 1 G.711u
Cisco VISM Installation and Configuration Guide
dsplncids
Cas DTMF
Tran Tran Ecan
ena ena ena
5-363