Session - Avaya P330 Reference Manual

Chapter 2 Avaya P330 Layer 2 CLI Commands
owner name
Example:
P330-N# rmon history 1026 1026 3/2 30 buckets 20 owner amir
history 1026 was created successfully
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".

session

User level: user, privileged, supervisor
Use the session command to open a session with a specific entity within a switch
or the stack. For example, you can open a session with the Routing entity of a
P330-ML switch in the stack, or with an the X330 ATM (or X330 WAN) sub-module
entity plugged into a specific switch.
Layer 2 commands are only available if you open a switch session with the
Master switch.
When you use the session command the security level stays the same.
The syntax for this command is:
session [<module_number> [switch|router|atm|mgp|wan]]
module_number
switch|router|atm|mgp|wan
Use the session command without any parameters to identify the stack master
and its slot number. It will list all the modules in the stack and their slot number
with the master module marked with an asterisk.
40
The owner name string.
(optional) The switch number.
If you do not specify this parameter, you will
get the list of modules within the stack.
(optional) The entity to which you want to
open a session. If you do not specify this
parameter, you will get the default entity of the
specific module:
switch - Layer 2 entity of the switch (see Note
below).
router - Routing entity.
atm - ATM entity.
mgp - Media Gateway Processor.
wan - WAN access router entity.
Avaya P330 Reference Guide