Configuring Lacp On A Port - Avaya 8600 Configuration Manual

Configuring LACP on a port

Configure LACP on a port to enable LACP.
Procedure steps
1. On the Device Physical View, select a port.
2. In the navigation tree, open the following folders: Configuration > Edit > Port.
3. Click General.
4. Click the LACP tab.
5. To enable LACP on the port, select the AdminEnable check box.
6. Configure the remaining parameters as required.
7. Click Apply.
Variable definitions
Use the data in the following table to help you complete the LACP dialog box for the port.
AdminEnable
OperEnable
FastPeriodicTime
FastPeriodicTimeOper
SlowPeriodicTime
Configuration — Link Aggregation, MLT, and SMLT
Variable Value
Sets LACP status to enabled for the port.
The default value is false.
Indicates the operational status of LACP for the
port.
The default value is false.
Specifies the number of milliseconds between
periodic transmissions using short timeouts for
all LACP enabled ports. The range is 200–
20000.
The default value is 1000.
The operating value of the fast periodic timer
on the port.
The default value is 1000.
Specifies the number of milliseconds between
periodic transmissions using long timeouts for
all LACP enabled ports. The range is 10000–
30000.
Configuring LACP on a port
January 2012 61