The Power Saving commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config power_saving global
config power_saving port
show power_saving
Each command is listed in detail, as follows:
config power_saving global
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[ [link_detection_scheduled | port_shutdown_scheduled | hiberantion_scheduled |
dim-led_scheduled | administrative_dim-led ]
[dim-led | hibernation] [add <range_name 8> | delete]]
[port_list <portlist> | all] [time_range <range_name 8> | clear_time_range]
{global | port}
To configure the power saving mode on the switch.
config power_saving global [[link_detection_scheduled |
port_shutdown_scheduled | hibernation_scheduled | dim-
led_scheduled | administrative_dim-led ] [enable | disable] |
time_profile type [dim-led | hibernation] time_range [add
<range_name 20> | delete] ]
The config power_saving global command is used to configure
the power saving mode on the switch.
link_detection_scheduled – Configure the link detection state to
enable or disable. The default value is disabled.
port_shutdown_scheduled – Configure the port shutdown state to
enable or disable. The default value is disabled.
hiberanation_scheduled – Configure the hibernation state to enable
or disable. The default value is disabled.
dim-led_scheduled – Configure dim led state to be enabled or
disabled.
administrative_dim-led – Configure administrative dim-led state to be
enabled or disabled.
[enable | disable] – Enable or disable the power saving feature.
dim-led – The dim-led type of time profile.
hibernation – The hibernation type of time profile.
add <range_name 8> - The time profile name to add for power
saving.
delete – remove the time profile for power saving.
Only administrator-level users can issue this command.
POWER SAVING COMMANDS
120
[enable | disable] | time_profile
21