CHAPTER 20
COSD System Log Messages
COSD_AGGR_CONFIG_INVALID
System Log Message
Description
Type
Severity
Facility
Cause
Action
COSD_CHASSIS_SCHED_MAP_INVALID
System Log Message
Description
Type
Severity
Facility
Cause
Copyright © 2010, Juniper Networks, Inc.
This chapter describes messages with the
class-of-service (CoS) process (cosd), which enables the routing platform to provide
different levels of service to applications based on packet classifications.
Error: Cannot have config error-message interface-name
The class-of-service (CoS) process (cosd) did not apply the config on this interface
because it was not valid in this case
Error: An error occurred
error
LOG_DAEMON
One possible cause is if any Class-of-Service is configured on an interface which is a part
of an aggregated interface
Remove or change the config from/on the interface.
Chassis scheduler map incorrectly applied to interface interface-name: error-message
The class-of-service (CoS) process (cosd) did not apply a chassis scheduler map to the
indicated interface, because the configuration used to apply the scheduler map was
invalid.
Error: An error occurred
error
LOG_DAEMON
One possible cause is that the chassis scheduler map is applied to a specific interface.
For most interface types, a scheduler map must be applied to all interfaces on the PIC;
therefore, a wildcard must be used to specify the interfaces. One exception to this rule
is the Gigabit Ethernet IQ PIC.
prefix. They are generated by the
COSD
213