Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 390

Junos 10.3 System Log Messages Reference
Type
Severity
Facility
KMD_CFG_IF_ID_POOL_RETURN_FAILED
System Log Message
Description
Type
Severity
Facility
KMD_DPD_FAILOVER_MANUAL_TUNNEL
System Log Message
Description
Type
Severity
Facility
KMD_DPD_FAILOVER_MAX_ATTEMPTS
System Log Message
Description
Type
Severity
Facility
Cause
KMD_DPD_FAILOVER_NO_ACTIVE_PEER
System Log Message
326
Error: An error occurred
error
LOG_AUTH
Unable to return logical interface to pool pool-name: pool not found
The key management process (kmd) maintains pools of logical interfaces for assignment
to IP Security (IPSec) interfaces. It could not return a logical interface to the indicated
pool, because it could not access the pool.
Error: An error occurred
error
LOG_AUTH
Tunnel tunnel-name did not fail over: it is manual type
An IP Security (IPSec) tunnel normally fails over to its backup when the key management
process (kmd) detects a dead peer. Failover was not attempted for the indicated tunnel,
which is configured as a manual type and so does not support failover.
Error: An error occurred
error
LOG_AUTH
Number of failover attempts exceeded limit count for tunnel tunnel-name
An IP Security (IPSec) tunnel fails over to its backup when the key management process
(kmd) detects a dead peer. The key management process (kmd) stopped making failover
attempts for the indicated tunnel, because the number of attempts exceeded the
indicated limit configured for Internet Key Exchange (IKE) Phase 1 negotiations.
Error: An error occurred
error
LOG_AUTH
Failover attempts can fail repeatedly if both the primary and backup peers are unreachable
during the failover.
Tunnel tunnel-name did not fail over: no active peer configured
Copyright © 2010, Juniper Networks, Inc.