Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 558

Junos 10.3 System Log Messages Reference
Type
Severity
Facility
RMOPD_ADDRESS_TARGET_INVALID
System Log Message
Description
Type
Severity
Facility
RMOPD_ICMP_ADDR_TYPE_UNSUPPORTED
System Log Message
Description
Type
Severity
Facility
RMOPD_IFINDEX_NOT_ACTIVE
System Log Message
Description
Type
Severity
Facility
RMOPD_IFINDEX_NO_INFO
System Log Message
Description
494
Error: An error occurred
error
LOG_DAEMON
rmop_util_set_address status message: error-message
When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it must specify the address of the target host along with the corresponding
address type (such as IP version 4 [IPv4]). Either the specified address was invalid
because it did not match the specified address type, or the address could not be resolved.
Error: An error occurred
error
LOG_DAEMON
Only IPv4 source address is supported
When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it can specify the address type (such as IP version 4 [IPv4]) of the source and
target hosts for the operation. The client specified an unsupported address type.
Error: An error occurred
error
LOG_DAEMON
ifindex: snmp-interface-index
When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it can specify which interface to use as the source host address, identifying it
by either its numerical index or its name. The indicated index was invalid because it
represents an inactive interface.
Error: An error occurred
error
LOG_DAEMON
No information for snmp-interface-index, message: error-message
When a Simple Network Management Protocol (SNMP) client requests a remote
operation, it can specify which interface to use as the source host address, identifying it
Copyright © 2010, Juniper Networks, Inc.