Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 282

Junos 10.3 System Log Messages Reference
Facility
Cause
Action
COSD_IFD_SHAPER_ERR
System Log Message
Description
Type
Severity
Facility
Cause
Action
COSD_INTERFACE_NO_MEDIA
System Log Message
Description
Type
Severity
Facility
Cause
Action
COSD_L2TP_COS_NOT_CONFIGURED
System Log Message
Description
Type
218
LOG_DAEMON
Shaping rate is valid only for interfaces housed by IQ and IQ2 PICs, and the interface is
on a different type of PIC.
Remove the shaping rate configuration from the interface.
port shaper not allowed on interface interface-name
The non-queuing dense port concentrators (DPCs) did not support the specified shaping
rate.
Error: An error occurred
error
LOG_DAEMON
The port shaper was not supported on the non-queuing DPCs.
Remove the shaping rate configuration from the interface.
Unable to obtain media information for interface interface-name
The message sent by the kernel for the indicated interface did not include required media
information.
Error: An error occurred
error
LOG_DAEMON
An internal software failure occurred.
Contact your technical support representative.
Unable to apply CoS to L2TP session session-id because session-aware CoS is not enabled
for interface interface-name
The class-of-service (CoS) process (cosd) did not apply CoS settings to the indicated
Layer 2 Tunneling Protocol (L2TP) session on the indicated interface, because the
interface is not configured to support session-aware CoS for L2TP. In terms of
configuration, the 'per-session-scheduler' statement is not included at the [edit interfaces
<interface-name> unit <logical-unit-number>] hierarchy level.
Error: An error occurred
Copyright © 2010, Juniper Networks, Inc.