Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 566

Junos 10.3 System Log Messages Reference
Facility
Action
RPD_BGP_CFG_LOCAL_ASNUM_WARN
System Log Message
Description
Type
Severity
Facility
RPD_BGP_NEIGHBOR_STATE_CHANGED
System Log Message
Description
Type
Severity
Facility
RPD_CFG_TRACE_FILE_MISSING
System Log Message
Description
Type
Severity
Facility
RPD_DYN_CFG_BUSY_SIGNAL_FAILED
System Log Message
Description
Type
Severity
Facility
Action
502
ANY
Modify the configuration statement to use a valid value.
local as-number cannot be set to confederation as-number data-id, statement ignored
Local autonomous-system number cannot be set to the confederation
autonomous-system number. Statement will be ignored.
Event: This message reports an event, not an error
warning
ANY
BGP peer peer-name changed state from old-state to new-state (event event-type)
During BGP negotiation with the local router, the state of the indicated BGP neighbor
(peer) changed as indicated. The ESTABLISHED state is the final state in the neighbor
negotiation.
Event: This message reports an event, not an error
warning
LOG_DAEMON
No file specified under traceoptions hierarchy
The routing protocol process (rpd) could not find the 'file' statement under a traceoptions
hierarchy. This would prevent it from performing tracing.
Event: This message reports an event, not an error
warning
ANY
Dynamic config action busy signal failed: error-message
The routing protocol process (rpd) failed to notify the dynamic configuration clients
about its availability to process the dynamic configuration requests.
Error: An error occurred
error
LOG_DAEMON
Contact your technical support representative.
Copyright © 2010, Juniper Networks, Inc.