Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 252

Junos 10.3 System Log Messages Reference
Severity
Facility
Action
CHASSISD_OFFLINE_NOTICE
System Log Message
Description
Type
Severity
Facility
CHASSISD_OID_GEN_FAILED
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_OVER_TEMP_CONDITION
System Log Message
Description
Type
Severity
Facility
Action
188
error
LOG_DAEMON
Contact your technical support representative.
Routing Engine offline: message
The chassis process (chassisd) took the Routing Engine offline.
Event: This message reports an event, not an error
critical
LOG_DAEMON
Unable to generate OID: oid (error-message)
The chassis process (chassisd) could not generate an object identifier (OID) for the
indicated object.
Error: An error occurred
error
LOG_DAEMON
Contact your technical support representative.
Chassis temperature over temperature degrees C (message); routing platform will
shutdown in duration seconds if condition persists
The temperature of one or more components (field-replaceable units, or FRUs) exceeded
the indicated temperature, which is the upper of two thresholds. The fans (and impellers,
if applicable) were in the indicated state. If the temperature does not go below the
threshold within four minutes after the chassis process (chassisd) detects this condition,
the chassisd process shuts down the routing platform. When this message was logged,
the indicated number of seconds remained before shutdown.
Error: An error occurred
error
LOG_DAEMON
Increase cooling in the area around the chassis.
Copyright © 2010, Juniper Networks, Inc.