Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 214

Junos 10.3 System Log Messages Reference
Facility
CHASSISD_FCHIP_PIO_WRITE_ERROR
System Log Message
Description
Type
Severity
Facility
CHASSISD_FCHIP_POLL_ERROR
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_FCHIP_RATE_ERROR
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_FCHIP_SIB_NOT_STARTED
System Log Message
Description
Type
Severity
150
LOG_DAEMON
Fchip fchip-id: write error in function-name() for link#link-id, at address address in register
register
The indicated routine failed with a write error at the indicated address and register for
the indicated F chip and link.
Error: An error occurred
error
LOG_DAEMON
Fchip fchip-id: link-type link-id poll returned error error-code
An error with the indicated error number occurred during polling of the indicated
high-speed receiver (HSR) or high-speed transmitter (HST) link for the indicated F chip.
Error: An error occurred
error
LOG_DAEMON
Contact your technical support representative.
Fchip fchip-id: per-port rate limit was not enabled
The chassis process (chassisd) detected that per-port rate limiting was not enabled
when it attempted to set the rate limit on an individual port for the indicated F chip.
Error: An error occurred
error
LOG_DAEMON
Contact your technical support representative.
Unable to start fru-name fru-slot because F chips were not initialized
The indicated Switch Interface Board (SIB) did not start because the F chips on it were
not initialized.
Error: An error occurred
error
Copyright © 2010, Juniper Networks, Inc.