Chapter 41 Jptspd System Log Messages - Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual

CHAPTER 41
JPTSPD System Log Messages
JPTSPD_INIT_FAILURE
System Log Message
Description
Type
Severity
Facility
Cause
Action
JPTSPD_OUT_OF_MEMORY
System Log Message
Description
Type
Severity
Facility
Cause
Action
Copyright © 2010, Juniper Networks, Inc.
This chapter describes messages with the
packet-triggered subscriber process (jptspd) which creates and manages packet-triggered
subscriber interfaces. A packet-triggered subscriber interface is created when the router
receives a packet with an IP source address that does not match any entries in the
demultiplexer table. When the router detects an unmatched packet, it generates a trigger
event that determines whether to create a dynamic subscriber interface or configure an
existing interface.
JPTSPD failed to initialize
The packet triggered subscriber process (jptspd) initialization failed.
Error: An error occurred
error
ANY
One possible cause is that the system is out of memory.
Contact your technical support representative.
Out of memory
The packet triggered subscriber process (jptspd) could not dynamically allocate memory.
Error: An error occurred
error
ANY
A software bug caused a memory leak, or too many subscriber and service sessions.
Contact your technical support representative.
prefix. They are generated by the
JPTSPD
313