Chapter 73 Rpd System Log Messages - Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual

CHAPTER 73
RPD System Log Messages
RPD_ABORT
System Log Message
Description
Type
Severity
Facility
Action
Cause
RPD_ACTIVE_TERMINATE
System Log Message
Description
Copyright © 2010, Juniper Networks, Inc.
This chapter describes messages with the
protocol process (rpd) which controls the routing protocols that run on the router. This
process starts all the configured routing protocols and handles all the routing messages.
It maintains one or more routing tables, which consolidate the routing information learned
from all routing protocols. From this routing information, the routing protocol process
determines the active routes to network destinations and installs these routes into the
Routing Engine's forwarding table. Finally, it implements routing policy, which allows you
to control the routing information that is transferred between the routing protocols and
the routing table.
NOTE: When an interface goes down, individual RPD_IGMP_LEAVE and RPD_MLD_LEAVE
messages are no longer generated per group or per host. Instead, a single message
(such as RPD_IGMP_ALL_SUBSCRIBERS_DELETED) is generated for the interface.
abort executable-name[pid] version version built by builder on date: error-message
The routing protocol process (rpd) terminated because of an internal error.
Error: An error occurred
error
LOG_DAEMON
Examine the messages that immediately follow this message in the system log for
information about possible causes.
An internal software failure occurred.
Exiting with active tasks: task-name
After receiving multiple termination requests, the routing protocol process (rpd) exited
without performing the indicated cleanup tasks.
prefix. They are generated by the routing
RPD
497