Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 209

CHASSISD_FASIC_RESET_ERROR
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_FASIC_SRAM_ERROR
System Log Message
Description
Type
Severity
Facility
CHASSISD_FASIC_VERSION_ERROR
System Log Message
Description
Type
Severity
Facility
CHASSISD_FCHIP_CONFIG_COMPLETE
System Log Message
Description
Type
Severity
Facility
Copyright © 2010, Juniper Networks, Inc.
Fchip (CB control-board-slot, ID fchip-id): reset failed
The chassis process (chassisd) could not reset the indicated F chip on the indicated
Control Board (CB).
Error: An error occurred
error
LOG_DAEMON
Contact your technical support representative.
Fchip (CB control-board-slot, ID fchip-id): SRAM fuse did not initialize
The chassis process (chassisd) detected that static RAM (SRAM) did not initialize properly
for the indicated F chip on the indicated Control Board (CB).
Error: An error occurred
error
LOG_DAEMON
Fchip (CB control-board-slot, ID fchip-id): part number part-number and version version
were invalid
The indicated part number and version detected for the indicated F chip on the indicated
Control Board (CB) were not valid values.
Error: An error occurred
error
LOG_DAEMON
Fchip: configuration already completed
The chassis process (chassisd) detected an attempt to configure an F chip when
configuration was already complete.
Error: An error occurred
error
LOG_DAEMON
Chapter 18: CHASSISD System Log Messages
145