Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 254

Junos 10.3 System Log Messages Reference
Severity
Facility
Cause
CHASSISD_PEM_BREAKER_TRIP
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_PEM_IMPROPER
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_PEM_INPUT_BAD
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_PEM_NOT_SUFFICIENT
System Log Message
190
error
LOG_DAEMON
In most cases, this error is caused by peers transitioning up and down unexpectedly. The
error is usually transient and nonfatal.
Circuit breaker tripped for power supply pem-slot
The circuit breaker was tripped for the indicated power entry module (PEM).
Event: This message reports an event, not an error
warning
LOG_DAEMON
Turn on the affected PEM manually.
Power supply pem-slot improper for platform
Old PEM is not supported in this platform.
Error: An error occurred
error
LOG_DAEMON
Replace old PEM with proper newer PEM
error-message for power supply pem-slot (status bits: 0xstatus-code); check circuit
breaker
The chassis process (chassisd) detected the indicated error condition for the indicated
power entry module (PEM).
Event: This message reports an event, not an error
warning
LOG_DAEMON
Check the status of the circuit breaker and the input connections.
Unable to power up FPC fpc-slot, because no three-input 240-A power supply is installed
Copyright © 2010, Juniper Networks, Inc.