Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 273

Description
Type
Severity
Facility
Action
CHASSISD_UNSUPPORTED_PIC_MODE
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_UNSUPPORTED_SIB
System Log Message
Description
Type
Severity
Facility
Action
CHASSISD_VERSION_MISMATCH
System Log Message
Description
Type
Severity
Copyright © 2010, Juniper Networks, Inc.
The indicated PIC is either not supported on this routing platform or is not supported by
the installed version of the chassis process (chassisd) software. The chassisd process
did not bring the PIC online.
Error: An error occurred
warning
LOG_DAEMON
Contact your technical support representative.
Application mode mode is not supported for PIC pic-slot in FPC fpc-slot
The indicated PIC does not support the indicated application mode configured for it.
Event: This message reports an event, not an error
warning
LOG_DAEMON
Check which application modes are supported for the PIC.
SIB with assembly ID assembly-id is not supported
The chassis process (chassisd) detected the presence of a new Switch Interface Board
(SIB) with the indicated assembly ID. The SIB remains offline, because it is not a supported
type.
Error: An error occurred
error
LOG_DAEMON
Contact your technical support representative.
Version mismatch: chassisd message version expected-value fru-name fru-slot message
version received-value local IPC version local-ipc-version remote IPC version
remote-ipc-version
As a component (field-replaceable unit, or FRU) comes online, the chassis process
(chassisd) verifies that the FRU's revision level or version is supported. The revision level
of the indicated FRU was unsupported or otherwise invalid.
Error: An error occurred
error
Chapter 18: CHASSISD System Log Messages
209