Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 564

Junos 10.3 System Log Messages Reference
RPD_AMT_TUNNEL_CREATE
System Log Message
Description
Type
Severity
Facility
RPD_AMT_TUNNEL_DELETE
System Log Message
Description
Type
Severity
Facility
RPD_ASSERT
System Log Message
Description
Type
Severity
Facility
Cause
Action
RPD_ASSERT_SOFT
System Log Message
Description
500
Tunnel created between gateway destination-address port destination-port relay
source-address port source-port on interface interface-name at time
AMT tunnel create event.
Event: This message reports an event, not an error
info
ANY
Tunnel deleted between gateway destination-address port destination-port relay
source-address port source-port on interface interface-name at time
AMT tunnel delete event.
Event: This message reports an event, not an error
info
ANY
Assertion failed executable-name[pid]: file "source-filename", line line-number: "message"
The source code for the routing protocol process (rpd) includes internal self-consistency
checks. A check failed at the indicated line number in the indicated source file, causing
the instance of rpd that was using the indicated binary and had the indicated process ID
(PID) to terminate. The process created a diagnostic core dump for analysis by technical
support personnel.
Error: An error occurred
error
LOG_DAEMON
An internal software failure occurred.
Examine the messages that immediately follow this message in the system log for
information about possible causes. Contact a technical support representative, and be
ready to provide the list of messages and the diagnostic core dump, if requested.
Soft assertion failed executable-name[pid]: file "source-filename", line line-number:
"message", daemon continued running
The source code for the routing protocol process (rpd) includes internal self-consistency
checks. A check failed at the indicated line number in the indicated source file, but the
Copyright © 2010, Juniper Networks, Inc.