Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 618

Junos 10.3 System Log Messages Reference
Cause
Action
RPD_RDISC_SOLICITLEN
System Log Message
Description
Type
Severity
Facility
Cause
Action
RPD_RIP_AUTH_REQUEST
System Log Message
Description
Type
Severity
Facility
RPD_RIP_AUTH_UPDATE
System Log Message
Description
Type
Severity
Facility
RPD_RIP_JOIN_BROADCAST
System Log Message
Description
554
The solicitation message was incorrectly generated.
Examine the host that generated the solicitation message.
Insufficient length (length) for router solicitation from source-address to
destination-address
The routing protocol process (rpd) ignored a router discovery solicitation message from
the indicated router, because the indicated message length is too short.
Event: This message reports an event, not an error
warning
LOG_DAEMON
The solicitation message was incorrectly generated.
Examine the host that generated the solicitation message.
Request with invalid authentication from source-address (interface-name)
The routing protocol process (rpd) ignored an RIP request because the request
authentication failed.
Event: This message reports an event, not an error
notice
LOG_DAEMON
Update with invalid authentication from source-address (interface-name)
The routing protocol process (rpd) ignored a RIP update because authentication of the
update failed.
Event: This message reports an event, not an error
notice
LOG_DAEMON
Unable to get broadcast address on interface-name; using the all-ones address
RIP cannot run on the indicated interface because the routing protocol process (rpd)
could not obtain the broadcast address on the interface as required for running RIP version
1 or version 2 in compatibility mode.
Copyright © 2010, Juniper Networks, Inc.