Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 625

Description
Type
Severity
Facility
RPD_RT_PREFIX_LIMIT_WARNING
System Log Message
Description
Type
Severity
Facility
RPD_RT_SHOWMODE
System Log Message
Description
Type
Severity
Facility
RPD_RT_TAG_ID_ALLOC_FAILED
System Log Message
Description
Type
Severity
Facility
RPD_SCHED_CALLBACK_LONGRUNTIME
System Log Message
Copyright © 2010, Juniper Networks, Inc.
The indicated total number of prefixes in the indicated routing table equaled or exceeded
the indicated configured limit. Attempts to add some types of prefix to the table fail while
this condition holds, but the prefix count can exceed the limit if prefixes are forcibly added
(for example, for static routes). This message first appears in the log when the limit is
reached and repeats periodically until the number of prefixes goes below the limit.
Error: An error occurred
error
LOG_DAEMON
Number of prefixes (prefix-count) in table table-name reached warning threshold
(threshold percent of configured maximum limit)
The indicated total number of prefixes in the indicated routing table reached the threshold
for a warning. The threshold is the indicated percentage of the indicated configured limit
on the number of prefixes.
Event: This message reports an event, not an error
warning
LOG_DAEMON
invalid display mode (mode)
The indicated display mode was specified in a 'show route' command and is unsupported.
Error: An error occurred
error
LOG_DAEMON
Unable to allocate object-name for routing instance instance
The routing protocol process (rpd) could not allocate either labels or subunits (as
indicated) for the indicated routing instance, because the result number of objects would
have exceeded the limit.
Error: An error occurred
error
LOG_DAEMON
function-name: excessive runtime time during action of module
Chapter 73: RPD System Log Messages
561