Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 194

Junos 10.3 System Log Messages Reference
Action
CFMD_CCM_DEFECT_MAC_STATUS
System Log Message
Description
Type
Severity
Facility
CFMD_CCM_DEFECT_NONE
System Log Message
Description
Type
Severity
Facility
CFMD_CCM_DEFECT_RDI
System Log Message
Description
Type
Severity
Facility
CFMD_CCM_DEFECT_RMEP
System Log Message
Description
Type
Severity
Facility
130
Verify that the configured continuity-check transmission interval does not differ from the
remote endpoint, and that the configured MEP ID is valid.
CFM defect: error-message
A connectivity-fault management (CFM) maintenance endpoint (MEP) received a
continuity check message (CCM) that contained a 'Port Status' or 'Interface Status' type,
length, value (TLV), which indicate a failed bridge port or aggregated port.
Event: This message reports an event, not an error
error
ANY
CFM defect: error-message
No defect was detected.
Event: This message reports an event, not an error
error
ANY
CFM defect: error-message
A connectivity-fault management (CFM) maintenance endpoint (MEP) received a
continuity check message (CCM) that had the 'Remote Defect Indication' (RDI) bit set,
which indicates that not all configured MEPs are returning CCMs to the transmitting MEP.
Event: This message reports an event, not an error
error
ANY
CFM defect: error-message
A connectivity-fault management (CFM) maintenance endpoint (MEP) did not receive
three consecutive continuity check message (CCM)s from one of the other MEPs in its
maintenance association (MA), which indicates a MEP failure or network failure.
Event: This message reports an event, not an error
error
ANY
Copyright © 2010, Juniper Networks, Inc.