Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 627

Facility
Cause
RPD_SIGNAL_TERMINATE
System Log Message
Description
Type
Severity
Facility
RPD_SNMP_CONN_PROG
System Log Message
Description
Type
Severity
Facility
RPD_SNMP_CONN_QUIT
System Log Message
Description
Type
Severity
Facility
RPD_SNMP_CONN_RETRY
System Log Message
Description
Type
Severity
Facility
Copyright © 2010, Juniper Networks, Inc.
LOG_DAEMON
The duration was noted because task accounting is enabled. The function might be
implemented inefficiently.
signal-name termination signal received
In response to the indicated termination request, the routing protocol process (rpd)
terminated adjacencies with neighbors and shut down.
Event: This message reports an event, not an error
notice
LOG_DAEMON
function-name: error-message
The indicated error occurred while the routing protocol process (rpd) was connecting to
the Simple Network Management Protocol (SNMP) master agent.
Error: An error occurred
info
LOG_DAEMON
function-name: unable to connect to SNMP agent (pathname): error-message
The routing protocol process (rpd) could not connect to the indicated Simple Network
Management Protocol (SNMP) master agent.
Error: An error occurred
error
LOG_DAEMON
function-name: reattempting connection to SNMP agent (pathname): error-message
The routing protocol process (rpd) tried again to connect to the indicated Simple Network
Management Protocol (SNMP) master agent after a connection attempt failed.
Error: An error occurred
error
LOG_DAEMON
Chapter 73: RPD System Log Messages
563