Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 188

Junos 10.3 System Log Messages Reference
Type
Severity
Facility
BOOTPD_CONFIG_ERR
System Log Message
Description
Type
Severity
Facility
Action
BOOTPD_CONF_OPEN
System Log Message
Description
Type
Severity
Facility
Action
BOOTPD_DUP_PIC_SLOT
System Log Message
Description
Type
Severity
Facility
Action
124
Event: This message reports an event, not an error
info
ANY
Problems with configuration file 'filename', using defaults
The boot parameter process (tnp.bootpd) could not read the indicated configuration
file, so it initialized using default settings defined at compile time.
Error: An error occurred
error
ANY
Correct the configuration file.
Unable to open configuration file 'filename'
The boot parameter process (tnp.bootpd) could not open the indicated configuration
file, so it initialized using default settings defined at compile time.
Event: This message reports an event, not an error
notice
ANY
Contact your technical support representative.
Duplicate default value defined for PIC pic-slot in FPC fpc-slot
As each hardware component on the routing platform initializes, it requests a boot string
from the boot parameter process (tnp.bootpd). The boot strings are defined in the
configuration file for tnp.bootpd. There was more than one definition in the file for the
indicated Physical Interface Card (PIC) slot in the indicated Flexible PIC Concentrator
(FPC), so tnp.bootpd used the first definition it found.
Event: This message reports an event, not an error
notice
ANY
Remove the extra definitions from the configuration file.
Copyright © 2010, Juniper Networks, Inc.