Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 563

Facility
Action
RPD_AMT_CFG_LOC_ADDR_MCAST
System Log Message
Description
Type
Severity
Facility
Action
RPD_AMT_CFG_PREFIX_LEN_SHORT
System Log Message
Description
Type
Severity
Facility
RPD_AMT_CFG_RELAY_INVALID
System Log Message
Description
Type
Severity
Facility
Action
RPD_AMT_RELAY_DISCOVERY
System Log Message
Description
Type
Severity
Facility
Copyright © 2010, Juniper Networks, Inc.
ANY
Modify the configuration statement to use a valid value.
Local-address route-prefix cannot be a multicast address
A multicast address cannot be configured as the local-address.
Event: This message reports an event, not an error
warning
ANY
Modify the configuration statement to use a valid value.
Prefix length prefix-length is too short for prefix route-prefix
The prefix length for the indicated prefix is too short and it has a non-zero host portion.
Excess host bits will be ignored.
Event: This message reports an event, not an error
warning
ANY
Invalid relay information is configured
Invalid relay configuration was encountered while parsing AMT configuration.
Event: This message reports an event, not an error
warning
ANY
Modify the configuration statement to use a valid value.
AMT relay discovery message from gateway destination-address port destination-port
at time
AMT relay discovery event.
Event: This message reports an event, not an error
info
ANY
Chapter 73: RPD System Log Messages
499