Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 619

Type
Severity
Facility
RPD_RIP_JOIN_MULTICAST
System Log Message
Description
Type
Severity
Facility
RPD_RSVP_BACKUP_DOWN
System Log Message
Description
Type
Severity
Facility
RPD_RSVP_BYPASS_DOWN
System Log Message
Description
Type
Severity
Facility
RPD_RSVP_BYPASS_UP
System Log Message
Description
Type
Copyright © 2010, Juniper Networks, Inc.
Error: An error occurred
error
LOG_DAEMON
Unable to join multicast group on interface-name: error-message
RIP cannot run on the indicated interface, because the routing protocol process (rpd)
could not join the RIP multicast group as required for RIP version 2 multicast updates.
Error: An error occurred
error
LOG_DAEMON
Backup for protecting LSP lsp-name down, using bypass bypass-lsp-namereason
When link protection is enabled, a backup label-switched path (LSP) is needed to
maintain a protected LSP's control-plane connectivity when topology failures are
detected. The backup LSP for the indicated protected LSP failed. The failure can cause
traffic loss because the protected LSP tears down when there is no backup. If the reason
for the backup failure can be determined, it is reported in the message.
Event: This message reports an event, not an error
warning
LOG_DAEMON
RSVP bypass bypass-lsp-name for protecting interface interface-name went downreason
The indicated RSVP link-protection bypass, which was protecting the indicated interface,
was terminated. If the reason for the termination can be determined, it is reported in the
message.
Event: This message reports an event, not an error
warning
LOG_DAEMON
RSVP bypass bypass-lsp-name for protecting interface interface-name came up
The indicated RSVP link-protection bypass was established to protect the indicated
interface.
Event: This message reports an event, not an error
Chapter 73: RPD System Log Messages
555