Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 701

UI_CHILD_STOPPED
System Log Message
Description
Type
Severity
Facility
Cause
Action
UI_CHILD_WAITPID
System Log Message
Description
Type
Severity
Facility
Cause
Action
UI_CMDLINE_READ_LINE
System Log Message
Description
Type
Severity
Facility
UI_CMD_AUTH_REGEX_INVALID
System Log Message
Description
Copyright © 2010, Juniper Networks, Inc.
Child stopped: PID pid, signal=signal-namecore-dump-status, command='command')
The management process (mgd) created a child process to execute the indicated
command for it. The child process received the indicated signal and stopped.
Error: An error occurred
notice
ANY
An internal software failure occurred.
Contact your technical support representative.
waitpid failed: PID pid, rc return-value, status status-code: error-message
The management process (mgd) created a child process to execute a command for it.
It could not wait for the child process to finish.
Error: An error occurred
error
ANY
An internal software failure occurred.
Contact your technical support representative.
User 'username', command 'command'
The indicated user typed the indicated command at the CLI prompt and pressed the
Enter key, sending the command string to the management process (mgd).
Event: This message reports an event, not an error
info
LOG_AUTH
Invalid 'allow-deny' command authorization regular expression 'regular-expression':
error-message
An operation that attempted to set command or configuration authorization included
the indicated regular expression. The operation failed because the expression syntax
was invalid.
Chapter 88: UI System Log Messages
637