Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 294

Junos 10.3 System Log Messages Reference
DCD_PARSE_ERROR_SCHEDULER_LIMIT
System Log Message
Description
Type
Severity
Facility
Action
DCD_PARSE_ERROR_VLAN_TAGGING
System Log Message
Description
Type
Severity
Facility
Action
DCD_PARSE_ERR_INCOMPATIBLE_CFG
System Log Message
Description
Type
Severity
Facility
Cause
Action
DCD_PARSE_MINI_EMERGENCY
System Log Message
Description
230
interface-name: exceeds the allowed limit (maximum-value) of 'per-unit-scheduler'
interface statement for PIC=pic-slot on FPC=fpc-slot
The 'per-unit-scheduler' statement is enabled on more interfaces than what this PIC
would suppport.
Error: An error occurred
warning
LOG_DAEMON
Remove the 'per-unit-scheduler' statement from the configuration for the interface.
interface-name: PIC type does not support flexible-vlan-tagging statement
The 'flexible-vlan-tagging' statement is included at the [edit interfaces] hierarchy level
for the indicated interface, but is not supported by the Physical Interface Card (PIC) that
houses the interface.
Error: An error occurred
warning
LOG_DAEMON
Remove the 'flexible-vlan-tagging' statement from the configuration for the interface.
configuration-statement : Incompatible configuration detected : warning-message
The interface process (dcd) found a configuration which will not be supported in future
releases.
Error: An error occurred
warning
ANY
This is a warning and the configuration will not be supported in future release.
Contact your technical support representative.
dcd_mini_config: errors while parsing configuration overlay
The interface process (dcd) encountered an unhandled internal state during interface
parsing.
Copyright © 2010, Juniper Networks, Inc.