Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 420

Junos 10.3 System Log Messages Reference
L2ALD_PBBN_IFL_REVA
System Log Message
Description
Type
Severity
Facility
Cause
Action
L2ALD_PBBN_REINSTATE_IFBDS
System Log Message
Description
Type
Severity
Facility
Cause
Action
L2ALD_PBBN_RETRACT_IFBDS
System Log Message
Description
Type
Severity
Facility
Cause
356
Unable to initialize Provider Backbone Bridging on interface interface-name. It is present
on a Rev A card.
The Layer 2 address learning process (l2ald) could not initialize the interface for the
provider backbone bridging (PBB) feature because the interface was on a revision A card.
Error: An error occurred
warning
LOG_DAEMON
Revision A cards do not support provider backbone bridging (PBB) features.
Contact your technical support representative.
Hardware VCs are being restored for data packet.They were de-programmed because
interface-name had an interface on a Rev A card.
The Layer 2 address learning process (l2ald) reinstated certain hardware circuits to
resume data traffic. The circuits were brought down because the provider backbone
bridging (PBB) feature had discovered that one of the interfaces was on a revision A card.
Error: An error occurred
warning
LOG_DAEMON
The interface is no longer present on the revision A card.
Contact your technical support representative.
Provider Backbone Bridging feature detected on interface interface-name on a Rev A
card. VCs are being de-programmed.
The Layer 2 address learning process (l2ald) retracted certain hardware circuits to block
data traffic. The circuits were brought down because the provider backbone bridging
(PBB) feature had discovered that one of the interfaces was on a revision A card.
Error: An error occurred
warning
LOG_DAEMON
An interface was discovered on the revision A card. Revision A cards do not support
provider backbone bridging (PBB) features.
Copyright © 2010, Juniper Networks, Inc.